When you unbox your Bradex BX60, you should find:
Initial setup:
This is the most critical technical part of the process. Follow these steps in order to prevent dangerous sparking.
Step 1: Preparation Turn off the vehicle’s ignition and all electrical components (lights, radio, AC). Ensure the charger is unplugged from the wall outlet and the power switch is in the "OFF" position. bradex bx60 battery charger instructions best
Step 2: Clean the Terminals Corroded battery terminals create resistance and prevent efficient charging. Use a wire brush or a battery terminal cleaner to remove the white/green powdery buildup from the battery posts (the + and – metal knobs).
Step 3: Identify the Polarity Identify the Positive (+) and Negative (-) terminals on your battery.
Step 4: Connect the Cables (The "Dead Battery" Rule) When you unbox your Bradex BX60, you should find:
Note: If you have removed the battery from the car entirely and it is sitting on a workbench, connect the Red to Positive and Black to Negative directly.
Step 5: Select Settings Look at the front panel of the Bradex BX60.
Step 6: Power Up Plug the charger into a standard wall outlet. Turn the switch to the "ON" position. Initial setup:
| Action | Do This | Avoid This | | :--- | :--- | :--- | | Connection | Clamps first, then mains | Mains first, then clamps | | Mode selection | Match battery type (STD/AGM) | Using Repair mode on a new battery | | Charging location | Dry, ventilated, above freezing | Wet, sealed, hot (>40°C) | | Float charging | Leave connected indefinitely for storage | Leaving in Bulk or Repair mode | | Disconnection | Mains off, then remove clamps | Pulling clamps off while powered |
A compact, user-friendly charger that revives small rechargeable batteries fast and safely — ideal for AA/AAA NiMH cells used in remotes, toys, and gadgets.
This is where most errors occur. Here’s the best rule of thumb:
If you set the wrong type, the BX60 may overcharge (damaging Gel/AGM) or undercharge (leaving flooded batteries sulfated).