Ddcs V3 1 Firmware Update -

Users on forums like MyCNCUK and CNCZone report:

The DDCS V3.1 firmware update trajectory suggests that by Q4 2026, we may see:

However, keep your expectations realistic. The V3.1 chip (STM32F407) has limited RAM (192KB). Massive features like 3D toolpath preview will never arrive—that is reserved for the DDCS Expert V4.0.

An unexpected addition: partial rigid tapping and encoder-synchronized motion for lathe mode. This suggests the DDCS V3.1 is creeping into light turning center territory.