100id Manual — Fanuc Arc Mate

The Arc Mate 100iD supports two touch-sensing methods:

(Excellent for standard FANUC + Lincoln/Miller setups; poor for other brands or custom gas/water control.) fanuc arc mate 100id manual

The manual contains a PM checklist that many shops ignore. Here is the condensed version for the Arc Mate 100iD: The Arc Mate 100iD supports two touch-sensing methods:

| Interval | Task | Manual Reference | |----------|------|------------------| | Daily | Check torch cable for cuts; verify compressed air dryer | Section 2.3 | | Weekly | Calibrate touch sensor with reference pin | Arc Tool Manual, p.45 | | Monthly | Grease J2, J3, J5 (3 pumps each) | B-83775EN, p.28 | | Quarterly | Check harmonic drive backlash (<0.5 mm) | B-83775EN, p.51 | | Annually | Replace battery pack, encoder backup battery | Section 6.2 | | 10,000 hours | Replace J4/J6 timing belt | Section 7.4 | The manual contains a PM checklist that many shops ignore

Note: Harmonic drive grease for J2 requires a special vacuum fill procedure. The manual warns: “Overgreasing J2 by more than 5% will cause overheating and thermal alarm SRVO-204.”

Most owners search for "Fanuc Arc Mate 100iD manual error codes" – that lives in the controller manual, not the robot manual.