|
||||||||||||
|
||||||||||||
Manual - Jkd-512com UserThe JKD-512COM operates in three distinct modes. Select yours using the rotary switch (S1) on the front panel. Q1: Can I use the JKD-512COM with a Raspberry Pi or Arduino? Yes. Use RS-232 (via level shifter) or Ethernet Modbus TCP. Example Arduino library “JKD-512COM” is on GitHub. Q2: The device gets very warm. Is that normal? Yes. The metal chassis acts as a heat sink. Operating temp up to 70°C is normal. If above 80°C, improve ventilation. jkd-512com user manual Q3: How to factory reset without physical access?
From USB console, enter: Q4: Can I log data to a USB flash drive? No. The USB port is for console only. Use the microSD card slot hidden under the front label (max 32GB, FAT32). The JKD-512COM operates in three distinct modes Q5: Does the JKD-512COM support TLS/SSL encryption? As of firmware v3.2, MQTT over TLS is supported via Ethernet. For serial, no. Q6: Why is my RS-485 communication corrupted? Common errors: missing ground wire, no termination resistor on long lines, or baud rate mismatch. Also verify all devices use same data encoding (e.g., 8N1). Connectors : Thank you for purchasing the jkd-512com. This device is designed for [purpose, e.g., serial communication / industrial control / data acquisition]. This manual provides instructions for safe installation, operation, and troubleshooting. |
||||||||||||
|
