L298 Motor Driver Library For Proteus Download Official

The L298 motor driver library for Proteus is an essential add-on for anyone serious about simulating motor control circuits. By following this guide, you can download, install, and use the L298 component in less than 10 minutes.

  • Add a 12V battery to Vs and 5V to Vcc.

    • To test your library, simulate an Arduino Uno running this code. You will see the motors change direction every 3 seconds.

    // L298N Motor Driver Test for Proteus Simulation
// Connect IN1 to Pin 8, IN2 to Pin 9, IN3 to Pin 10, IN4 to Pin 11

    #define IN1 8
#define IN2 9
#define IN3 10
#define IN4 11
    

    void setup() 
pinMode(IN1, OUTPUT);
pinMode(IN2, OUTPUT);
pinMode(IN3, OUTPUT);
pinMode(IN4, OUTPUT);
    

    // Enable pins in Proteus (Assume ENA/ENB tied to +5V)
Serial.begin(9600);
Serial.println("L298 Simulation Starting...");
 l298 motor driver library for proteus download
    

    void loop() 
// Motor A Forward, Motor B Forward
digitalWrite(IN1, HIGH);
digitalWrite(IN2, LOW);
digitalWrite(IN3, HIGH);
digitalWrite(IN4, LOW);
delay(3000);
    

    // Stop both motors
digitalWrite(IN1, LOW);
digitalWrite(IN2, LOW);
digitalWrite(IN3, LOW);
digitalWrite(IN4, LOW);
delay(1000);
    

    // Motor A Reverse, Motor B Reverse
digitalWrite(IN1, LOW);
digitalWrite(IN2, HIGH);
digitalWrite(IN3, LOW);
digitalWrite(IN4, HIGH);
delay(3000);
    

    // Brake (Stop again)
digitalWrite(IN1, LOW);
digitalWrite(IN2, LOW);
digitalWrite(IN3, LOW);
digitalWrite(IN4, LOW);
delay(1000);
 The L298 motor driver library for Proteus is

    Viewing the Output: Run the simulation in Proteus. You should see the "MOTOR-DC" components spinning clockwise, stopping, then spinning counter-clockwise.

    L298 Motor Driver Library for Proteus — Download & Installation Guide

    void setup() 
  pinMode(8, OUTPUT);
  pinMode(7, OUTPUT);
  pinMode(9, OUTPUT);

    void loop() 
// Forward at half speed
digitalWrite(8, HIGH);
digitalWrite(7, LOW);
analogWrite(9, 128);
delay(2000); Add a 12V battery to  Vs  and 5V to  Vcc
    

    // Reverse at full speed
digitalWrite(8, LOW);
digitalWrite(7, HIGH);
analogWrite(9, 255);
delay(2000);

    Run the simulation. You will see the DC motor rotate forward, stop, and reverse—exactly as coded.