Skip to Content

Motorola Radio Programming Software Rvn4191.14 -

Before you spend hours searching for this software, verify that your radio is on the compatibility list. RVN4191.14 is not universal. It will not work with the newer MOTOTRBO digital series (like the XPR 7000 series) or the legacy Saber/Maxtrac series.

The open-source CHIRP radio programming software supports some Motorola commercial radios, but it does NOT support the Professional Series (HT/CDM) . Do not use CHIRP for RVN4191.14 radios; it may corrupt the codeplug. motorola radio programming software rvn4191.14

Because RVN4191.14 is DOS-based, modern Windows (10/11) cannot run it natively. You will need: Before you spend hours searching for this software,

  • Motorola RIB box – Required to convert RS-232 levels to radio-logic levels.
  • Programming cable – Specific to your radio model (e.g., for HT600/MT1000 use a 2-pin or 5-pin accessory connector cable).

    • Assuming you have a legal license and a vintage Windows XP laptop, here is the general workflow: Motorola RIB box – Required to convert RS-232

    Most two-way radio shops have a "legacy programming bench." They can program your HT1250 or CDM1550 for a bench fee (typically $25–$50 per radio). This saves you the licensing, hardware, and time investment.

    | Problem | Likely Cause | Solution | | :--- | :--- | :--- | | "Communication error" | No RIB or bad serial port | Check RIB batteries (9V), cable continuity, COM port address. | | "Model mismatch" | Wrong software version | Verify radio model is truly supported; try different RSS release. | | Frozen screen on read/write | Computer too fast | Use a slower PC (< 100 MHz) or enable serial slowdown utilities. | | Error #157 / Checksum fail | Corrupted codeplug or poor connection | Re-seat cables, retry read. If persists, radio may need service. |

    More Reading