🚨 BUY 2 KITS SAVE $200 (CODE: SPECIALTWO)

Mt6769z Scatter File Instant

  • Extract from Your Own Device:
  • MTK Droid Tools (Legacy): Older tool but works for pre-Android 11 MT6769Z devices if rooted.
  • Set Download Mode:
  • Connect the Device:
  • Start Flashing: Click the green Download arrow. A progress bar will appear.
  • Completion: A green checkmark circle means success. Disconnect and reboot.

    • When you open the MT6769Z_Android_scatter.txt in a text editor (like Notepad++ or Sublime Text), you won't see binary gibberish. Instead, you'll see structured data. Here is a breakdown of a typical section:

    - partition_index: SYS0
  partition_name: preloader
  file_name: preloader_mt6769z.bin
  is_download: true
  type: SV5_BL_BIN
  linear_start_addr: 0x0
  physical_start_addr: 0x0
  partition_size: 0x400000
  region: EMMC_BOOT_1

    If your MT6769Z phone shows no signs of life (black screen, no vibration, not recognized by PC), the bootloader or preloader is likely corrupted. Using the correct scatter file, SP Flash Tool can force-write the boot chain back to the eMMC. mt6769z scatter file

  • Formatting: When saving this text, ensure the file extension is .txt (commonly named MT6768_Android_scatter.txt or scatter.txt).
  • Offsets: If you are manually creating a scatter file, the linear_start_addr (offset) is critical. If these numbers are wrong, you will write data to the wrong part of your chip, causing a hard brick.

    • Recommendation: If you are trying to fix a phone, download the exact firmware for your device model rather than using a generic scatter file. Extract from Your Own Device:

    | Error Code | Message | Solution | | :--- | :--- | :--- | | STATUS_BROM_CMD_SEND_DA_FAIL (0xC0060003) | DA didn't send | Reinstall MTK USB drivers. Use USB 2.0 port. | | STATUS_ERR (0xC0010001) | S_DL_GET_DRAM_SETTINGS_FAIL | Scatter file mismatch. You loaded an MT6765 scatter on an MT6769Z. Get the correct file. | | STATUS_SEC_AUTH_FILE_NEEDED (0xC0030012) | Auth file required | Newer MT6769Z devices (Android 12+) need an auth_sv5.auth file. Use SP Flash Tool with DA (Download Agent) from the firmware folder. | | Error: Status_Size_Too_Large | Partition too large | You tried to flash a super.img bigger than the super partition size defined in scatter. Repartitioning required (advanced). | MTK Droid Tools (Legacy): Older tool but works