| Pin | Signal | Notes | |-----|--------|-------| | 1 | PUL+ | Step pulse input (+ common or +5–24V) | | 2 | PUL- | Step pulse sink | | 3 | DIR+ | Direction input | | 4 | DIR- | Direction sink | | 5 | ENA+ | Enable (active high or low – check) | | 6 | ENA- | Enable return | | 7 | ALM+ | Alarm output (open collector) | | 8 | ALM- | Alarm return |
Common wiring modes:
If this is indeed a PSA automotive tool, the "driver" alone is not enough. You cannot just plug it in and expect Windows to recognize it as a usable tool. You need the Diagbox software suite.
Since PSA XS Evolution is obscure:
If you own a PSA XS Evolution marker, the 9780Z5 driver is a reliable, smooth-shooting upgrade over earlier bolt systems. However, new players may find it finicky with lube and tank output pressure. For tournament use, it holds its own against the Gamma Core (Planet Eclipse) but lacks the aftermarket support of more common platforms.
Buy if: You already have the marker and want a consistent, quiet shot.
Skip if: You use an SLP tank or hate bolt stick in cold weather. psa xs evolution 9780z5 driver
The PSA XS Evolution (9780.Z5) is a dealer-level diagnostic interface (VCI) used for Peugeot and Citroën vehicles. The primary "driver" for this device is not a standalone file but is bundled within the DiagBox, Lexia 3, or PP2000 software suites. Driver & Software Report
Driver Identification: In Windows Device Manager, the interface is typically identified as "USB Com Board Evolution Driver".
Official Support: Modern drivers for the "XS Family" (Basic+ and Lite) are available directly from the manufacturer, ACTIA IME, supporting Windows 8, 10, and 11 (x86/amd64).
Legacy Systems: The original software was designed for Windows XP or Windows 7 (32-bit). Users on newer operating systems often need to use a Virtual Machine (VM) running Windows XP to ensure compatibility with older Lexia/PP2000 versions. Installation Steps
Software First: Always install the diagnostic software (e.g., DiagBox) before plugging in the hardware. | Pin | Signal | Notes | |-----|--------|-------|
Driver Setup: During DiagBox installation, the "PSA VCI Driver" is usually installed automatically as a separate component.
Hardware Connection: Once the software is installed, connect the VCI to your PC via USB. Windows should detect the "USB Com Board" and apply the driver.
Interface Checker: To ensure the device is communicating correctly, many users use a small utility called Interface Checker to verify or update the firmware (e.g., version 4.2.4 is a common stable build). Common Issues PSA XS Evo driver help | Peugeot Forums
Check current firmware version: Use psactl --device=COM5 --version. Latest stable: v3.2.1.
| Parameter | Typical Value | |-----------|----------------| | Supply voltage | 24–70 VDC (check label) | | Phase current | 2–5 A RMS (peak 7 A) | | Microsteps | 1/2, 1/4, 1/8, 1/16, 1/32, 1/64 | | Control signals | Step/Direction (5–24V logic), Enable, Alarm out | | Connectors | 5-pin screw terminal (motor), 2× 6-pin (control & power) | | Form factor | ≈ 100×70×25 mm, DIN rail or base mount | The PSA XS Evolution (9780
Since a specific "9780Z5" driver does not exist in a standalone, official download link, you must identify the chipset inside the device.
Step 1: The Hardware ID Method This is the most reliable way to find a driver for any unknown device.
Step 2: Match the ID
Many PSA 9780z5 devices still run on industrial PCs with Windows Embedded Standard 7 or even XP.
