Sc67310 Ricoh Error Extra Quality May 2026

Replace the IPU board (PN: D1475113). When replacing:

After IPU replacement, print a Color Calibration Chart (SP2-194-001) and calibrate using the scanner or a spectrophotometer (if equipped) to restore "extra quality" mode.

---

If you can access the Service Program (SP) Mode despite the error, attempt to reload the firmware. sc67310 ricoh error extra quality

1. Initialize the Hard Disk (Data Loss Warning) This is the first step recommended by Ricoh technicians.

2. Check Physical Connections If the format fails or the drive is not detected, open the controller unit (usually the side panel) and ensure the SATA cable and power cable connected to the HDD/SSD are secure. Replace the IPU board (PN: D1475113)

3. Replace the Hard Drive If formatting does not clear SC67310, the Hard Disk is physically defective. You will need to replace it with a compatible Ricoh HDD or SSD. After replacement, you must reinstall the system firmware.

The SC673-10 is often caused by a weak 3.3V or 5V power supply to the IPU, not a failed board. After IPU replacement, print a Color Calibration Chart

Fix (extra quality focused):

Firmware update (critical for quality):

In SP Mode:

---