Skope Heated Towel Rail Timer Instructions May 2026

Skope heated towel rails are often paired with external timers like the Heirloom Timekeeper Plus

or similar digital controllers to maximize energy efficiency. These timers allow you to automate heating cycles so your towels are warm exactly when you need them. Setting the Current Time

To ensure your programmed schedules run correctly, you must first set the internal clock:

Access Setup: If your timer has a front latch, pull it from the bottom to reveal the buttons.

Set Day/Time: Press and hold the CLOCK button. While holding it, use the HOUR, MIN (minutes), and DAY keys to adjust to the current settings. Save: Release the CLOCK button to store the data. Programming a Heating Schedule skope heated towel rail timer instructions

Most digital controllers allow you to set specific "On" and "Off" windows for different days of the week:

Enter Program Mode: Press the PROG (or PG) key once. The screen should display "Timer 1 On".

Set "On" Time: Use the HOUR and MIN keys to select when you want the rail to start heating.

Set "Off" Time: Press PROG again until "Timer 1 Off" appears. Use the same keys to set the finish time. Skope heated towel rails are often paired with

Confirm: Press the CLOCK button to exit and save your schedule. Using Pre-Set "Eco" Modes If you are using a simplified controller like the Heirloom Timekeeper Plus

, you can cycle through automatic cycles by pressing the main button:

3-Hour Boost: Press once; the rail runs for 3 hours and stays off.

Morning Cycle: Press twice for 5 hours on / 19 hours off daily. To switch modes: Press the Mode button repeatedly

Dual Cycle: Press three times for 4 hours on / 8 hours off twice daily.

Even Split: Press four times for 6 hours on / 6 hours off daily. Quick Tips for Best Use Setting a Digital Timer(Step by Step Instructions)

Even with perfect instructions, issues arise. Here is how to fix them.

Skope towel rails generally have three modes displayed on the screen:

To switch modes: Press the Mode button repeatedly until the cursor on the screen points to "AUTO."

Your Skope timer allows up to 8 ON/OFF events per day. For a typical bathroom, you only need 2 events: Morning and Evening.