The user manual prescribes a maintenance routine:
âš DANGER: Before cleaning or repairing, isolate main power supply. Wait 2 minutes for capacitor discharge. âš WARNING: Do not operate with wet hands. Keep the touchscreen free from grease, film residue, and sharp tools. âš CAUTION: Pinch points exist near sealing jaws and film pull rollers. Keep hands clear during automatic cycling.
The SmartPack2 Touch is an advanced electronic control system used primarily on sewer cleaning combination trucks (combination jetting/vacuum units). It replaces traditional analog gauges and manual levers with a digital touchscreen interface, allowing the operator to control the high-pressure water system, vacuum system, and engine parameters with precision. smartpack2 touch user manual
Key Benefits:
The SmartPack2 Touch is a programmable control unit designed for industrial packaging lines. Its 7-inch capacitive touchscreen interfaces with PLC-driven actuators (heat sealers, film feeders, cutters). This manual covers safe startup, parameter configuration, fault recovery, and daily maintenance. The user manual prescribes a maintenance routine:
The system supports 50 recipes.
| Problem | Likely Cause | Solution | |---------|--------------|----------| | Touch strip unresponsive | Sleep mode or low battery | Charge pack. If charged, re-activate via button hold. | | LED strip shows red, but pack charged | Moisture on touch strip | Dry with cloth. If persists, reset (see below). | | Heated pocket not warming | Battery below 15% or pocket empty | Charge pack. Ensure pocket has contents (safety sensor). | | Charging stops mid-way | Overheating protection | Unplug devices, let pack cool for 15 min. | | Alarm triggers randomly | Phone Bluetooth disconnected | Disable anti-theft mode when not moving. | âš DANGER: Before cleaning or repairing, isolate main
| Fault Displayed on Screen | Haptic Feedback | Corrective Action | | :--- | :--- | :--- | | Temp Sensor Open | Double vibration pulse | Check thermocouple plug on the rear PCB; replace sensor. | | Film Break | Single long vibration | Thread film; tap "Clear Fault" on the pop-up dialog. | | E-stop Pressed | No vibration; screen dim | Rotate physical E-stop button clockwise; confirm green status bar. | | Touch Unresponsive | Continuous vibration | Clean screen with microfiber cloth; avoid gloves with metal fibers. |
| Feature | Detail | |---------|--------| | Battery capacity | 10,000 mAh (37 Wh) Li-Po | | Input | USB-C 18W (5V/3A, 9V/2A) | | Output 1 (standard) | 5V/2.4A max | | Output 2 (fast) | 5V/3A, 9V/1.67A (15W max) | | Heated pocket temp | 40°C ± 2°C | | Touch strip lifespan | 100,000 gestures | | Water resistance | IPX3 (rain resistant, not submersible) | | Weight (empty, battery included) | 1.6 kg (3.5 lbs) |
Powered by Discuz!
© 2001-2019
