Exit automatically after 15 seconds of no input.
Simultaneously press ▲ + ▼ for 5 seconds until screen flashes
---. Release. Unit resets to F1 = C, F2 = 25°C, F3 = 2°C.
Typical simple flow:
Problem: The screen shows "EE" or "E1".
Problem: The relay is clicking constantly. Stc-600 Temperature Controller Manual Pdf
Problem: The reading is 2 degrees off from my thermometer.
The STC-600 is a compact digital temperature controller used for heating/cooling applications (incubators, fermenters, aquariums, small ovens). It supports dual setpoints, PID control, hysteresis/ON‑OFF modes, and alarm outputs. Exit automatically after 15 seconds of no input
| Code | Function | Default | Range | Description | |------|----------|---------|-------|-------------| | F1 | Heating differential | 2.0°C | 0.1–15°C | Heating stops when PV ≥ SV | | F2 | Cooling differential | 2.0°C | 0.1–15°C | Cooling starts when PV ≥ SV+F2 | | F3 | Temperature calibration | 0.0°C | -10–10°C | Adjust sensor deviation | | F4 | Compressor delay | 0 min | 0–10 min | Anti-short cycle delay | | F5 | High temp alarm | 110°C | Off, SV–120°C | Alarm if PV > F5 | | F6 | Low temp alarm | -50°C | -50–SV | Alarm if PV < F6 | | F7 | Working mode | 0 | 0 or 1 | 0=Cooling priority, 1=Heating priority | | F8 | Restore defaults | 0 | 0 or 1 | Set to 1 to reset all settings | | F9 | Temperature unit | 0 | 0 or 1 | 0=°C, 1=°F |
If you have recently purchased an STC-600 Temperature Controller for your home brewing setup, aquarium, or incubator, you are likely holding a powerful little device with a somewhat confusing interface. Like many microprocessor-based controllers, the STC-600 comes with a factory preset that might not suit your specific needs. Simultaneously press ▲ + ▼ for 5 seconds
To unlock its full potential, you need the STC-600 Manual PDF. In this post, we will cover where to find the manual, how to navigate it, and a quick reference guide for the most common settings.