Visual Audio Splitter Amp- Joiner 12 Serial

Why would you need 12 channels of splitting and joining simultaneously? Here are real-world scenarios.

To use the Model 12 as a standard splitter: Set all toggles to OUT. Each stage’s Split Output receives a copy of the input (post-Input Trim), but each Split Output is individually buffered. This yields 12 isolated, low-impedance outputs at unity gain.

Most audio gear is either a splitter (1 in, many out) or a joiner (many in, 1 out). Rarely do you find both in a 1U or 2U rack chassis. The Visual Audio Splitter Amp-Joiner 12 Serial contains twelve independent sections. Each channel strip generally features:

The "Serial" aspect allows you to link Channel 1’s output to Channel 2’s input internally via a front-panel switch, creating a daisy-chained amplifier array.

During a large installation commissioning, you need to send pink noise to 12 different loudspeaker processors. Set the device to Split Mode. Feed pink noise into Input 1; the 12 serial amplifiers drive 12 balanced lines across the building. The visual LEDs confirm tone is present at the rack.

Producers with 12-output audio interfaces can use the Joiner mode to sum 12 individual DAW tracks (Drums, Bass, Synth, Vocals) into a stereo mix through the unit’s high-headroom analog amplifiers, then split that summed signal to a monitoring system and a mastering recorder simultaneously.

Why would you need 12 channels of splitting and joining simultaneously? Here are real-world scenarios.

To use the Model 12 as a standard splitter: Set all toggles to OUT. Each stage’s Split Output receives a copy of the input (post-Input Trim), but each Split Output is individually buffered. This yields 12 isolated, low-impedance outputs at unity gain.

Most audio gear is either a splitter (1 in, many out) or a joiner (many in, 1 out). Rarely do you find both in a 1U or 2U rack chassis. The Visual Audio Splitter Amp-Joiner 12 Serial contains twelve independent sections. Each channel strip generally features:

The "Serial" aspect allows you to link Channel 1’s output to Channel 2’s input internally via a front-panel switch, creating a daisy-chained amplifier array.

During a large installation commissioning, you need to send pink noise to 12 different loudspeaker processors. Set the device to Split Mode. Feed pink noise into Input 1; the 12 serial amplifiers drive 12 balanced lines across the building. The visual LEDs confirm tone is present at the rack.

Producers with 12-output audio interfaces can use the Joiner mode to sum 12 individual DAW tracks (Drums, Bass, Synth, Vocals) into a stereo mix through the unit’s high-headroom analog amplifiers, then split that summed signal to a monitoring system and a mastering recorder simultaneously.